Hello together Heue I picked up my new S3…provisionally I wanted to read out the error memory and encode 2 things. At the AUTOSCAN (VCDS) it has “hanged up” 2 times and there is an error message. After that I installed VCDS again…reading worked out. No errors…TipTop. When “adapting” the start/stop function, the control would bring me if I wanted to change the values to 50, an error –> value inadmissible. Does anyone know why? When I select STG 09 (on-board network) STG access rating -> Function 16 Enter access code 31347 STG adaptation -> Function 10 channel (6) – daytime running light – continuous running light enabled in addition Select stand light value to be active …made…did not tell me VCDS –> measurement block available. Furthermore, VCDS said that it does not know the control unit and I should send the data to RossTech support. Does anyone have advice? Tom