Hi friends, I have the following problem: after a cold running controller from TwinTec was installed in my EG3, the engine runs a bit restless and the speed of the stationary gas is low, I think about the 700 RPM. This leads to the engine sometimes running out. Yesterday was pretty rough: I was driving on a country road, wanted to drive up to the highway, before turning off uncoupled, braked, foot from the gas and there the engine goes off! And so it happened a few times. I was scared, white l when driving the oil control light approached, thought already the engine gives up the mind, but was not like that 🙂 The funny thing is, when I turn off the light, it doesn’t go out, it’s still restless. I think if I slightly increase the speed in the stationary gas, then the problem would have to be solved. The question: how can I set the stationary gas speed? Is there somewhere a screw or something? Greeting fasimba