Hello Oldie-Fangemeinde, my Catalina Safari goes into the painting from next week. Until he is back, I need a few spare parts, but I don’t know what these are called, neither in German nor in English. Have already looked a little at RockAuto among the universal parts, but there are really a lot of them – and many look extremely similar… Maybe you can help me with the selection and I would have some questions right away: – First of all need Is it possible to use universal parts? – The small triangular window in the rear doors – there is the seal as hard as plastic and crumbles away. I don’t think that this is a universal part. The disc is not glued in either, therefore – you get to buy this seal, and if so – where? – The middle bridge between ver Is that correct? If yes – where do I start with the dismantling? Is there also the decorative strip on the outside… – I am still looking for door seals for the front doors – so far without success. I already have the rear ones. Who can call me a US shop – hits the keys, boys. For the rear seals I have paid 60 USD plus inch/shipment – the front seals should not be more expensive either. and you easily pay 200 – and I don’t want to finance any of its thick AMG… – How do you take out the front/back side windows? The rear ones are only half retractable, so they have to be removed for the exchange of the seals. – Is there perhaps the inner door handles covered with brown leather still to buy? I mean those that are attached to the top of the doorboard with chrome-plated holders. I unfortunately don’t have a picture… The one on the driver’s side is already over. – Hec Is there still and if yes – where? – the most important question: Water has run through the roof rail and the chrome trims on the roof. The entire roof has set flight grate, which is not further tragic. Worse is that the water has run down the A-pillar and has damaged it quite strongly. The same picture in the trunk – the rust has already raged in the rear light shafts. Can one seal these beams? Otherwise I have to enter the Sour apple bite and put 2 blobs of body glue around the screw holes – then the part is also immortalized on the roof… – Yesterday cut out the front window. Unfortunately some decorative moulding clips went with broken. Reason were sometimes, because the front window was not professionally mounted – extremely much glue on the sides, disc not centered and the clips were partly glued with. These clips have a long hole and are on small pins If yes – where? – the chrome trims on the roof are fixed from above with TX screws. These have a small sealing ring, which I would like to exchange with. Think that the screws are offered. For hints I am very grateful. Last but not least: The Visko fan is apparently defective – the car is crying like a vacuum cleaner. The fan is already turning at full power, even if the engine is still cold. If so – do you have an address to which I can contact? I would also need a heat switch for the water cycle. Has anyone ever done the conversion before? If so – where do I get the parts and maybe there are help in the net? These would have been the most important questions now. Look forward to your answers. My regards – Maik My regards – Maik