Hello, I bought the WE ne GPZ750 UT,EZ 1988, 54000km, TÜV new, all bearings (lenkkopf, Schwingenlager etc.) i.o., Batt. new. The car also runs sweating only at the cylinder foot a bit of oil and rattles in the stand gas (but this is already almost normal with the Kawa engine, at higher speeds you can hear nothing more!), is probably the control chain tensioner and the valves, which should be adjusted again and the carburettors I also have to adjust and synchronize. But now to the actual question: The box has such a funny Sachs handlebar cladding, looks shitty and I would like to build an original cladding on it again and build the thing up original again. The antler for the original cladding is not included. I have now seen in EBAY ne 1100UT cladding and the antlers get there too, but the boxes have come on the market with different claddings, one looks like the ones of the 900 GPZ ( so full covering), then there was the one with half covering (motor not disguised), but all KX750A (KZ750E). Question: Does the covering of the 1100s fit there, or which is the right covering now??? Have no cock there what to buy afterwards what does not fit, am grateful for every tip!!