The fuses look OK so far; the water pump still works. And at the front everything is OK (permanent, interval, water). To look back to the right, I wanted to remove the cover – anyway, because the trunk light has been shining permanently for some time now. Now I have a problem. Here in the forum I found the tip that you can see that the light is always on the right side. If I loosen the two screws and pull them out, the lower part of the cover will dissolve without any problems; there are 2 holding plugs that will dissolve immediately. But there is nothing moving up (to the disc)! From the position of the plastic noses, which I can still see, I would assume that you have to press towards the disc. But that alone it is not yet… Then I noticed that the wiping water not only has to be removed. the nozzle sprays out, but also out of the now semi-open cladding. Probably the water is then also the reason that the boot switch does not work properly anymore?! Questions: – Do I have to press the cover in a certain direction / rub it, push it somewhere or is there any other hot tip? – is the wiper motor switched over a separate fuse, or together with the water pump? – can I save anything as layman at all if there is water splashing out, o the wiper motor is usually so broken that I need a new one anyway? Unfortunately, this seems to be a common problem… Thank you for your help! mr