I drive a 850 EZ. 1995, which still has the flashbox for the self – blinking. ABS light burns, error codes 3-1-3 and 3-1-4 , which means that the rear right and left ABS sensor is open or interrupted. I removed the two sensors, cleaned them and could not find anything striking. I wanted to delete the error code for control now, but this does not work. According to the instructions I did the following: Test pin in socket 3 (ABS), button longer a press ls 5 sec. – red LED goes on – then press again button longer than 5 sec., LED goes off. Ignition off, ignition back on, control on the flash box. Should come 1-1-1. I had both error codes flashed out as required before the deletion process…for safety several times. But it still happens 3-1-4 – which affects the left sensor at the back. Question: did I do something wrong? Shouldn’t the error be deleted until at least a few meters away ahren ist? Looking forward to your ideas. Greeting Micah