Hello mopped screwdriver 😉 Bin motorcycle beginner. I bought a FZR 600 3He. This has always ratted in idle. Screwdriver technical I am gifted, only of motorcycles no idea. Troubleshooting as follows: – Clutch screw emptied out (the part under the pinion cover where the clutch train is in) The part replaced, clutch train replaced immediately. Then found that the thrust bar was torn off, the last end could simply pull out. So this also To do this, I removed the lid on the right side, removed the pressure plate, pushed out the push rod, new one in and vice versa. NOW: Problem. Despite laying the gears the machine does not unplug. Apparently I made a mistake somewhere. I suspect the error on the right side, because on the left it should fit from the lever path etc. How do the screws have to be tightened with the springs from the pressure palm? Completely or only half or how? Must the pressure palm be somehow aligned Is the push rod too little in it? Please help me further 😉 Thank you in advance 😉