Finally…. I finally got a new (or intact) moulded sky for my worry child. It cost me 400 km of motorway ride, 2 chickenburgers and a green glow. Now I have the exact instructions, but wonder if I can use temperature-resistant body glue instead of the not exactly defined glue. From Audi I had picked out D172090A2 – 27,97 € or D190MKDA3 – 33,20 €. If conventional glue without the 4 rings on it fulfills the same purpose in itself quality, I would save a few cents, which I can then pump into the car elsewhere. 2. Question. Could one imagine a thin, heat-insulating position between the roof skin and the molded sky from ???, in order to minimize the heat effect in the future especially in dark vehicles? I am grateful for every tip. I wanted to expand the old sky carefully, if necessary make a print / cast off and then reclaim it in the expanded state.