First hello, because I’m new here on the forum, and only because I’m facing a problem that I can’t explain to myself. The problem is this: I live in a secluded forest, and to get to the city, I have to overwhelm 2 times a stab. Up until now everything has always run bare, but yesterday something happened, which made me stunned. Just before I had reached the end of the stick with the scooter, this has gone out. I dach te , ok make him back on , and continue driving , because that can happen in the best families . I make the box again with e starter on , no problem , give gas , the part drives 2 meters , and goes off . Well I thought , could once again lie on the carburetor , I turned around , and the stab down . Here the cart has pulled again correctly , is normal driven , and also did not go off . To come now to my house , I have to drive up a small hill , which ends in a sharp left turn, but then continues flat again. I tried the height up, again the same problem. Just before the doll goes out the cart again. Strange. I then pushed it with light gas to the level track, put on me, and, if nothing had happened, drove up to the driveway to my house, which, yes, there is also a small mountain to overcome, also a little steep leads up. The same game from the front . 20 meters super the hill up, just before the house door goes the cart off. Today I removed the carburettor, built it apart, and cleaned in the ultrasonic bath for an hour. The part back together, then built, piece driven down the slope, turned around, and up again……….The same problem in green. A buddy of mine meant, the lying on the ventilation of the bezin tank, another on the piston rings, and a third I meant need a new kar Re. What now? Does someone here in this forum have an idea, an idea or an inspiration, why the part so spins? I would look forward to an early answer, because I am dependent on the part.