Hello, today I wanted to install a set of track plates from Eibach (16 mm per side, 32 mm per axle), the variant for screwing with separate wheel nuts. Rims are standard. However, the mounting now fails due to the supplied Eibach wheel nuts M12x1.5×18.5 in SW17 KG60°, because these look too far out or are too wide with SW 17 or the casting pockets of the OEM rims are too narrow. I think the too narrow casting bags are decisive. On the side of the nut to the edge of the bag, so that the rim can not fit plan. How can I get this solved now? The TÜV report says for mounting: M12x1.5 with minimum 6.5 revolutions are to be used. No word about the length/height of the wheel nuts. Could I simply use M12x1.5×16.5 in SW17? Would now be 2 mm flatter, but there would be only H&R. Also here there would be flatter up to M12x1.5×15. Or is there no longer the strength due to missing thread length? https://www.rad screwen-shop.de/…/M12x15 20 mm Track widening will not fit without bodywork and I don’t want to file on the supplied wheel nuts or rim.