Good morning, municipality. I have (again) a problem with my rims (BBS RZ 370) Unfortunately I got the idea that the rims were produced for Opel and not, as the previous owner had actually told me, for VW. As a result they have a smaller center hole diameter of 56.6 mm instead of the 57.1 and therefore do not fit on it of course. Now someone offered me, that the rims can be clamped on the lathe and the 0.5 mm can be turned off easily. However, m I suspect that a decrease would not be possible if the examiner could find it. 2. To what extent would the rim be affected by the stability of the rim in terms of tearing, rupture ect. Would be nice if someone knew about it and could tell me something about it (but please without – DU,DU,DU and raised index fingers ) Aja and I could use the original VW wheel bolts (Kuelbund) if the rim had its own h is designed for cone bundle screws or would there be any problems? Sorry for so many, probably “bold” questions but in terms of rims and so I really am an absolute greenhorn. Greetings, Jörg