Good morning, I renewed the days every 2 feathers on my Caprice – around ACDelco from Rockauto. Now the pot stands at the front about 1″ too high, fits in the back. Looks like shit. Rock offered me an exchange, but the change (I took the variant from the Shop Manual, where you release the two inner screws from the crossbar) was definitely in the top 3 of the worst repairs of my car screwdriver life. Didn’t know when I cursed so much the last time… Of course, I want to avoid the same thing happening with the replacement springs and therefore ask for some experience. I have added ACDELCO 45H0007 (front; limousine; classic Brougham; classic LS Brougham; with air conditioning) incl. new spring bearings above. As I said, the car is about 1″ too high, it lacks about 100kg load per wheel to press everything in shape. In the stand the new ones were not even higher than the original springs, but just installed. The repair is 8 Woc I can hardly imagine the installation errors that cause 2-3cm of height – you guys? If I go on Moog or something now I have bumble be that it goes back to the same, because the feathers are in themselves the right ones. And as I said, the change is an absolute catastrophe, I don’t want to go on without being sure that it fits. So, now I am grateful for every advice and every opinion… Greetings Matthias