Hey guys! Did jmd have experience with paint pens from you? So I ordered one (after I had found the color code of my bike). Unfortunately, the whole thing was not a real pen, but a brush with which to apply the paint in thin layers. Only I ask myself (after several attempts) now how to apply the paint with a brush, first thin and second so that at the end also a smooth surface is created. I wanted with the “Stift” several small S The one scratch was already quite deep and went through all the lacquer layers up to the bare plastic. Sure, there is a perfect result required too much, but I had at least hoped that the pen would make the black plastic surface appear blue again. Unfortunately that was not so. And the light scratches can still be seen, because it is not possible, as already mentioned, with a brush a smooth and immediately The second construction site was a small paint damage on the steel tank (probably rockfall). But here, too, the result was far below my expectations. The Macke is now looking at i-wie soagr even more than before… Can you possibly give me a tip on this brush dung? Is there a special trick that only incarnate selfmade painters know?? Has jmd experience with nem straighten LackSTIFT? Is that better, or is the result similar to schlec ht? P.S.: Pictures are still available tomorrow! Thank you for your time! Wish you all a good start to the season!! Greetings, Basti