Hey guys, I retrofitted the front EFH’s on my 95. Wire harness in the doors was completely replaced, as in the original there were no connections for the engines inside. Connection for the switches under the Miko. were there, even already switched through to the A column. High-low run everything goes, comfort lock via IR-ZV hand transmitter goes also, NOT over keys in the driver’s door. Furthermore, the EFH’s go after turning off the engine and open the driver’s door no longer to operate. If I turn the ignition on and off again, they continue to operate manually (until the door is closed). The ZV goes as usual via IR FB and key. Additional question, in the wire harness now also the 2 connections for the door lamps are included, but this has no power. On which pins on the A column they should be.