now I have to build 2 blacklight tubes in the car at the pedals and stop at the passenger (at the feet down there), which I wanted to connect to a 3 channel switch, from the switch should go cable to the battery and to the amplifier (in the channel where the bass signal for the subwoofer comes) which is short: off/on/to the bass light, since blacklight is mostly cold light it always flickers briefly when switching on or lights correctly only after a short time, if you start them ” n” and then switch to the bass she would always turn on and go out, ask 3: 1. would the tube then just flicker as is usual with cold light when switching on/off? 2. the channel from the amplifier gives 1100watts, is that too much/sufficient/too little to operate the tube properly without the subwoofer having to suffer from it? 3. if that is present with the flickering, wouldn’t there be any evasive options? zb blacklight LED chain/tube