Hello, my car has been driving around quite restlessly since the last workshop stay. At the speed the car pulls away to the right. The chassis has been measured and I have received the protocol, but I don’t understand so much. I once attached it with. The fall in front is still further beyond the tolerance after resetting it. Also, the spread seems a bit strange to me, because the value differs from left to right, is that okay? Kan What exactly does one read the target angle? In the case of the fall of the rear axle e.g. the fall should be 1°20′, but may differ by +0°30 or -0°30. On the left and right, however, it may not be like 0°30 apart?