Hello, with my car (Hyundai Santa Fe SM from 2001) it is very difficult to get the drive shaft out, according to a forum article, to that in another post it is necessary to exchange the axle cuff (wheel side) . According to my research not much are good axle cuffs to stick – but the posts were all older. Now I wonder if there are now good glue cuffs or if there are possibilities for permanent repair of the axle cuff. ch a bitumen repair tape for gutters attached to the defective cuff and these with cable ties – this is of course not a permanent solution but maybe someone has a good idea. What is not obvious to me as a layman is that one needs fat in the drive shaft if this anyway due to the centrifugal forces does not stick to the joint during the ride … maybe someone can explain that. Currently only one cuff is affected but the other 7 also look porous, i.e. i.e. h will have the problem more often because I want to drive the car for a long time, so I’m only looking for permanent solutions. Thank you very much for tips and nice Easter! Greeting Stefan