Hello Municipality The following problem Have an Audi 80 B4 Avant 2.6l Autom. The following parts at the front farwerk replace shock absorbers, crossbars, dome bearings, coupling rods Since this is made, I have, when I drive over a bumpy road a very strong poldern,bloppen on the left front wheel. Have removed the cover of the dome bearings in the engine compartment again and am the opinion that the plate hits on my body. What can this be about? Are all the original parts of Audi, di The 80 ́s have problems with the chassis, but this is already hard. I’m really desperate. You can’t change that at all, can you? Was yesterday at the track setting and on the left side the workshop was also able to set. Although it was very difficult (with rawer but went. To the right the track bar is rusted and has to be tamed. The funny thing is that this extreme hit on the left side only after measuring and adjusting Can it be that the mechanic has broken something here? Also the upper plates in the engine compartment sit quite far away from the carroserie. about 5mm. On the varnish I see that this plate apparently hits on the carousel. Please give me some tips. After question Radio I had a gamma and now a andres built in. the reception is mamasig! Does the antenna have to be controlled in some way? I used to have something else. do with phantom power. What is that and does the antenna need that too? Is a roof antenna mounted. I am DANKBAR over any help. Please !! Thank you in advance!! Cruß Cyber