Hi all, I have a question regarding cruise control: Vehicle: Omega B 3.0V6 Sport, BJ 1997, model year 98. Would like to retrofit a cruise control with my omi. I already have the turn signal lever with the corresponding switches. Wiring harness is also prepared, i.e. the 4-pole plug is on the steering stick lever and the plug for the control unit in the engine compartment is also available. Unfortunately I can not get the contact plug on the steering stick switch because there are 2 noses, which are in the same Now my question: May I unwrapping these (are cast out of Kunsstoff) or have one function. Inside each is a spiral made of metal, which in my opinion have no special function. I still have to install the actuator with the electronic gas train (used by an MV6). Can all this then work after Tech2 activation or are there problems? I am grateful for any tip. Greeting Omibilli