Short form: Did someone already have a stop of the charging over MeCahrge after 3 minutes? How can one refresh the position of the EQB when it is a few hours old, but the remaining data are up to date, also the time at the mileage? Long form: Did on Sunday in Eben in the Pongau 4 charging attempts with MeCharge card made. Ergebis was every time, start with little kWh goes up to 100kWh and everything looks good. But about 3 minutes the charging process breaks off. Nothing. Also annoying: in Austria it is billed according to time, from 20 to 80% on a good column 43 cents per kWh. In the 4 attempts 1.60 for 3×53 cents with charged 2.2 kW it was 72 cents! Then I drove on to Rennweg and tried it again: the column remained stuck in the status starting. Then the EnBW card used and almost continuously charged with 100 kWh from 20 to 80%. It cost 60 cents per kWh, but I could continue driving. It was striking if I used meApp de n EQB had been looking for on the map, which stood all the time at the border in Piding. Turn off, finish 5 minutes wait did not help either. Is there a “feature” that the charging will be stopped if the vehicle “is not at the charging station”? So to prevent abuse? In the evening the EQB was in Döbriach at Lake Millstatt (in the app and in reality) and the next day also the meCharge charge from 50 to 80% with 47 cents worked.