hello dear community, short to me:I have not been actively involved in the forum so far, always read only. from now on I’m with you 🙂 now to my problem: it’s a buick roadmaster from 1956.322 cui with dynaflow automatic transmission. start of the engine over once entering the gas pedal. the engine starts(gasifier=rochester 4 compartment=was already disassembled, cleaned and resealed),if I give in running engine,in stand gas,gas,it swallows itself,or in other words,it takes the gas Not immediately, only if the speed is slightly higher then it comes on tour.I have to say that the ignition has already been tried to adjust something (rotate the distributor head) as well as the adjustment screws on the carburetor the settings of the buick shop manual(workshop manual).It is further that, when the engine is running, the speed of the drive stage D or L goes into the cellar, which the car almost runs out,and by that it is the gas as described above bad accept,then run out of gas. am a little desperate to have for every idea. wish you all a good slip(not with the car 🙂 greetings from the thomas area