Hello, has any of you installed exactly these tire pressure sensors and they work?https://www.ebay.de/…/283646115205 I don’t have anything to do with them. In retrospect, they fell on top of the A*sch again. I was recommended and I bought them. In the auction it says: “The sensors are already pre-programmed and ready for use, they only have to be learned about the vehicle”. With my ignorance I thought now, install and the vehicle recognizes the Senso after a certain learning phase (car ride) of itself and everything is done. Puster cake! After two weeks and more than 500 km of car ride, the menu still shows the tyre pressure in the display: display only when driving. So the Stinger does not recognize the sensors by itself. I was back at the tyre dealer who installed the rims, tyres and these sensors to me. I did not buy the components there, but only had the assembly done. He could do with two different Only with the ATEQ reader it worked. He went into the device menu, selected Kia Stinger in 2018 and left the four sensors (clockwise) according to the default from the front left to the back left (clockwise) and said then I had to drive now 20 minutes … ???? For me illogical, because no data exchange between the car ECU and the reader took place. I thought that he now has to send the read out data via OBD to the control unit? I also have the ebayer “If you don’t have an automatic learning process, you either have to learn it stationary with a device or via OBD2. Programmed means that these are programmed for your vehicle.” I also found no information in the operating manual (on-board book). I don’t look through at all and only know that I am the doofe. For me, the ebayer’s information in the auction is wrong and the reason is rather an au I also find the procedure of the tyre dealer with the device incorrect/unlogical. But as written, I am ignorant. If I only had the original rubber sensors from Korea sent me for the same price. Does anyone know any advice?