Servus, at my Kawasaki Z125 I switched the turn signals in front and rear for LED turn signals (https://bit.ly/3nozl2q) and the turn signal relay for a load independent (https://bit.ly/3yZOmtr). The machine only has one turn signal control lamp for both sides. My problem is that if I want to blink, no turn signal will work, but the control light will light up permanently, so it doesn’t flash as normal. I had already tested the function after I had the rear turn signal. n Blinker was the first to switch, back then the original blinker had still worked properly at the front and the indicator light flashed, but the new rear blinker didn’t. I had changed the new blink relay again in hindsight for the original, the result remained the same. Does anyone have an idea what it might be due to? My next step would have been to reinstall the original relay and solder the resistors. LG Simon