Servus into the forum, I have in my vehicle a VAG 1.2l TSI engine CBZB, the above-mentioned error are pending. When driving with constant speed highway, after approx.10-15min) the car goes into the emergency run, no more power etc. Vehicle once restart, error away. Landroad is no problem, by the permanent load change the problem appears to not occur here, the turbo also runs. I tap on an error in the actuator of the Wastegate flap control! If I write the values of the placer, the target and actual position between each other, the default setting in the “Autobahn operation” is at approx. 70% and the actual position by the 0%! The actuator re-learn also works. The pole (in the case of engine) moves by hand, shows the desired changes. In case of load changes, the target and actual value of parts are equal to 0%, then the actual value of the set value runs up nicely constantly. The actual value of the charging pressure runs smoothly and is constant with the target value. If my target value is affected by the variable, then the limit value must be changed.