Hello again, I need your support again.Hab had my aerox so far to run and also the driving was really good.Had made 6.5g weights after the yamaha frie said that the originals were better.Before 3 and 5g weights were in from the previous owner.suit super but final speed equal to 0.After changing to 6.5 he comes down sluggishly to the back out he spins well.Fill me net,have now mixed with 5 g and 6.5g.At and pull well,although I manc hmaal has the feeling that he always has a small hole in the middle area.If it is on the weights, does it fit at all or can one mix it or is it net so good.The other problem is that I can’t adjust the carburettor (GurtnerPy12).Has the mixing screw out 1.5 revolutions before which it went quite well.Only when starting it went short after leaving the rotating extremely high so that the rear wheel turned with it.Is it at the setting?Today at once the adjustment adjusts ng with 1.5 revolutions no more, the mixing screw turned completely in and then 1 revolution out again,so he remains at least,but when I drive he suddenly does not take any gas properly in the middle range.When starting it goes through well,only when taking off gas and then accelerating again it does not work, does not accept as and no speed.How do I have to adjust.When I turn out af 1.5 change again, so left around, the speed goes down and then it goes out. Setting to 1 turn out but actually be the right one or how do you see that.bin despairing.