REX rs4500 (Capriolo Km-Stand 4050): Checking the CDI (reduced) – very concrete question In the systematic troubleshooting (roller no longer starts) I measured the CDI with my mulitmeter. The check of all connections of the CDI went positive, except the connection mass-to-second coil, since the multimeter (adjustment to ohm measurement, ignition on/off) does not say a muck. Now to you the very concrete question, whether the ignition coil is necessarily broken and I therefore simply and then everything is good again? Or should I rather measure a bit further? a few hints: Ignition doesn’t make a kickstarter do not go dipped light, speedometer lighting and speedometer indicators no longer go but horn, brake light, flashing light and flasher work WORKSTATTREPARATUR: spark plugs and carburetors are new, as well as turn signal relays (was smeared through), ventilation hoses Vario and air filter (air filter has been cleaned) have been renewed hope , this is not too vague for a remote diagnosis, but I would be very happy about some qualitative assessments/tips. Unfortunately, the workshops near me refuse to look at the scooter – too bad experiences – so that I have to try to get to the bottom of the matter (as far as possible). thanks and greetings, pb