so now that you all know, I have converted my omi to pöl . today or yesterday I started and I finished half an hour ago. I have now increased the nozzle pressure by a little bit 40 bar fact from it it runs even quieter and Kleichsämiger as before times look what the sprite consumption should actually go down it jumps again fundamentally better to the force unfolding is much more uniform. abraits upwand ca 5 std however without the suction bridge to temontieren m only the cover and the rear support for the fuel lines or for the wire harness screw always make sure that the overwhelm nuts were not slipping up to the esp was ne animal-like fummelei esp works from the noise background a bit harder let’s see if there is any change in the injector nozzles ka one can disassemble without propleme and the vohanden blades in the head for stronger exchange in the needle lifting sensor were 2 sheets inside 2x 1.05 mm in the other nozzles 1.5 mm you can calculate e tenths of mm each about 10 bar pressure more would have to stand so mometan between 185-200 bar as it was cold he jumped immediately without preferential glows unfortunately at a nozzle the return nipple break down to luck I had nen old needle stroke sensor still lying around I pulled off and built up Runs wonder bar should someone still have questions about it just here or with PN gruss Hannes yawn it’s early in the morning and I am dogs tired good night