Hi guys, let’s ask the cracks among you: …. well, there will be a few more questions …. Moped: FXSTS Have the original MT90B16 74H on the back. First of all the breakdown – as far as I can see (please correct, false!) 90 is width in mm, 16 is the rim diameter in inches, 74 is the load ratio and H of the speed index up to 210 km/h. But what is MT and B? Next story – had asked a while ago what could be built without a new swing. 170 or 180mm should go, as far as I remember. However, the Fender Struds and the laying frame fixture, as well as the Fender, should believe in it. Let the new rim ring be pointed in, adjust, Pneu on it, balance, eat well. I have taken a closer look at the thing before. In the attached picture it can be seen that the tire is installed about 2 cm to the left offset. The distance from the tire to the fender on the left is about 2 cm, to the right about 3.5 cm. On the right I have only about 5 cm, on the left I have about 6.5 cm. Do I have a kink in the optics or what? Is the Pneu rear really offset at a 2001 Softail or is that just an optical story? Would be grateful for information. Sers street-jumper