Hello, I have recently had a Phaeton 3.0 TDI GP3 from 2012 with approx. 120tkm of mileage and read here for a while. I noticed that my Phaeton is quite hard in the height adjustment “Normal” and chassis on “Comfort”. Furthermore, the bumper touches almost the ground even at a low kerb (see photo). Therefore today times measured: Come at around 370mm height from center wheel hub to wheelhouse edge. If I have researched correctly, that’s about 30mm too little. Nter the car has revealed an adjustable pole of the height sensors. So it is deliberately animal-fed by the previous owner. VCDS shows a height deviation in front of -3.0mm in the MWB. I bought the car for comfort reasons and am a friend of originality, so I want to reset everything like series. In the parts catalog I found the sensors only completely with poles and would now reluctantly exchange all sensors for just under 600€. Is there somewhere a source where only the Gest For setting with VCDS I would proceed as follows: – ECU address 34 – Access key 31564 – Adaption/Customization select – Channel 01: 407mm enter – Channel 02: 407mm enter – Channel 03: 401mm enter – Channel 04: 401mm enter – Channel 05: 1 enter to confirm During the procedure the engine is running and all doors are closed. –> Forget something? Thanks and greetings Ulti