Hello, have been driving a V70 II for 6 years and at some point had this “known” problem with the spinning central locking system. All 10-20 locking operations the driver door immediately opened again. I did it when it didn’t start to get repaired, I just didn’t want to spend so much money on it (was 50% on kulanz). I just paid attention if the driver door was always going too well and it was good. A few times the two times occurred, then I just got the F ahrertür closed by key. But now it gets annoying. For a few days the passenger door also started with it, but really bad. When it starts you have to climb the moose again and lock the passenger door by hand, otherwise you have no chance. Now my question: Supposedly these errors arise because microswitches in the door lock spin. Is it really so that you absolutely have to replace the door locks completely? In an earlier thread became an alleged craft solution with microswitch of Conrad mentioned, but specifically I could not find any information about it. Does anyone have a hint? Is the door panel difficult to get down? Probably not if I have accumulated enough anger… Thanks and greeting, toshimon