Hello together, I have installed various loudspeakers in my Audi with Audi Sound System. Specifically, my question revolves around the front system, which consists of a woofer and tweeter in the doors, as well as a midrange driver in the dashboard. These three loudspeakers are led via the original wire harness to a common amplifier output. For about 1.5 years I have installed a DSP from Audiotechnik Fischer, which drives the three loudspeakers via this common output. Each speaker is equipped with a crossover, which I have retrofitted. I am now thinking about remodeling the system to control each of the three speakers with an extra channel with the DSP – keyword sound quality. I have to move three pairs of cables from the DSP to each speaker. However, the speakers should remain connected to the original cable tree so that I simply have to expand the DSP when selling the vehicle and install the OEM amplifier. f the amplifier side would of course not be plugged in. Would that be possible or current flows over the original wire harness, where it should not? Have painted this up, hope that is so understandable. OEM cable harness in blue, in red the desired wiring