Hello all, I had some quilts in the back side of my car. Cut out, base varnish applied and covered with clear varnish. Spray box 2K clear varnish from Mipa in two layers. After the first pass I had strong orange skin, which I had then sanded and polished. Unfortunately, through the grinding shop there were some deeper grooves inside which I did not get out. Finally I had also sanded through in some places. So surface again roughened and again clear varnish in 2 layers. Again, the result is so that it has to be sanded and polished again in order to get a nice smooth surface. Shortly after varnishing it looks good, after drying then orange skin is there again. My question would be, is it at all possible to get a larger surface with a clear varnish spray can so that you do not have to grind again smooth? The rules, such as distance, temperature etc. are known to me and were also observed.