Hello parish. My topic was closed yesterday, in order to make a mistake on my part. I thought the Gianelli exhaust would have been cut off because I didn’t see anything in the depot. According to the internet there is such a throttle but front direction motor. Is that this washer? There’s one in me, it’s welded. The old exhaust (TecniGas) has no washer in front or rear. Still have a small problem. After I get the electrical from the Aprilia MX 50 back If I want to switch into 1 gear and go, then the planer comes a bit heavy out of the kink. I can’t get up the mountain with us at all. I have set the empty run and Co. as it was in the manual. In idle it also runs nicely calmly and gas takes it immediately without muking. According to the manual a Dell’ Orto 16 is installed. The previous owner has a Polini CP 15 built in. HD is an 84. The needle stands in the middle K spark plug is a new one, so no spark plug image at the moment. Recently a Gianelli exhaust (cutter + ESD ) was also installed. What exactly do I have to do to get the Aprilia back in power? Or is it possibly not on the carburetor? Mfg Dammy