Hello together, yesterday my friend wanted to leave and it was already the first gear difficult to go in but ok I thought it is normal that when the car was standing that doesn’t fluff.. After a short time (3 min) the gears could only be inserted with extreme power and a switching was almost impossible. The reverse gear also literally crashed in. Even during the driving the gears could only be changed by force. Then turned around and the car turned off and it showed up at get Reten clutch of the cars in the first gear and in the reverse gear began to roll. From this I conclude that the clutch does not separate cleanly. Today we wanted to go to the workshop and I get into the car (not moved since the defect ) and it is as if nothing had been. Car runs almost perfectly from the switch… This scenario repeats itself for a long time now and comes out of the blue. The only thing “helps” is when you turn off the engine and all the gears times with and without the hit clutch switched through and then starts completely normal. In 80% of the cases then everything works again. What can this be???! If the back bearing or the clutch itself were over then this would have to be the case or not?! By the way, the clutch is operated over a rope hoist, is an old car greeting and thank you!