Hello, since about 1 week we have an error message at our Captur. Almost every time when getting into the vehicle, the error message “tire printing initialize” arrives after starting. Also sometimes after a short stop or leave the captur. The vehicle was placed in the garage one day before without an error message. On the next day, ignition on, vehicle then makes the system check, instead of the message “OK” only the said indicator. (Tire printing has not changed – I have checked again and again. It is always the same with cold tyres as set at the door) Was in the workshop. There the normal procedure as I have already done at home was repeated. Summer bikes are already on it for a while. So far without any problems. Since Tuesday the car is in the workshop. Now I was informed that a presentation car has the same problem. Urpludentially. To understand: In the indirect system, the wheel turns are compared during the ride via the ABS sensors. But if when getting in comes the message that I should confirm in the on-board menu, what can not be true to Tom, or something like the manufacturer.