Moin together, next construction site. The door panel of the driver’s door dissolves so slowly. The material is a kind of insulation board. This is now soft and shabby, the corners are sometimes no longer available and the fastening nipples are torn out. From the chrome strip down it is really gammelig. For repair I have thought of three different possibilities. 1. Glue with a mixture of wallpaper paste and Ponal wood glue. The secret recipe from my teaching as Schaufenstem a) Punch in, pull in and let dry several times from the inside with the stuff, so that it becomes stable again. To hold the shape, you have to fix with plastic foil, two wooden plates and screw clamps. b) Do not mix missing parts with several layers of paper generously overlapped. Also fix here. c) Cut the overhanging corners suitable after drying and cut holes for the plastic nipples. 2. GRP, the hardcore a) The part completely from the inside with fluüssi (c) After drying, cut and drill holes for the nipples. To protect the leather or spray with silicone spray. 3. Rebuild plywood cladding. This can only be done with straight spots, such as the bottom part from chrome strip. Armrest and handle groove are OK. (a) Place and mark cladding on plywood, saw out b) With polyester and S Toffbahnen connect the transition between the original part and the replica. Which of the three possibilities is useful here? Or is there something else? After that the decoration comes with a new carpet. Whether I should stick it again in the original green or rather match the car in red I don’t know yet. Greeting Achim