Hey guys, I’m just making myself a huge head.. and I don’t even know if it’s right. I set the valves on my ZX10 2006. Can do that without any problems and I know myself too. I reinstalled the camshafts on OT marking all great. Spanners in, then something with the hand turned the motor through, spanners out and it must have happened. Since I didn’t fix the chain with the hand it is while spanning (spanner moves out) and at the same time spin out skipped around several teeth. I didn’t notice this at first, so I turned the motor by hand and suddenly a resistance came where I didn’t get any further and I stopped directly, so I didn’t try to get over it with force. I knew directly what was wrong. I expanded everything again and now everything fits. My question however: I think the inlet valves touched the piston at the resistance. Now I am totally afraid that I bent the valves e. My mind tells me that you can’t push valves crooked only by turning your hand. And how did I say that when I didn’t get anywhere, I stopped right away. Do you think it’s possible to press the valves only by turning their hand crimped? Bzw. if you don’t even press them with force.