Hey, I wanted to talk to the other BLIS drivers among us. My BLIS doesn’t seem to get along super well with city traffic and sometimes gets annoyed. It comes to the following errors: 1.) Warning right after the start: BLIS: Maintenance required The LEDs and cameras work completely normal, however, as always. BLIS restarting in this case does not bring anything, the message remains. However, if I restart the car, the error message is gone. That happens once every 2 weeks. 2.) BLIS: Camera blocked, corresponding LED flashes This is the most annoying thing about the system. In the dense traffic this message comes several times on my daily routes. Last week the system shot down the bird and played crazy 4 times (!!) on 18km city traffic – sometimes right, sometimes left. Here are several possibilities: a) car restart, BLIS initia It’s new and the error is gone b) let it flash for about 30 seconds, which unfortunately distracts enormously until the camera realizes that it’s not blocked and continues to work normally c) turn off BLIS. If you start it again, the LED flashes but cheerfully on – then you have to wait as with b) until the electronics calm down themselves. I usually only know one with BLIS, but it doesn’t drive in city traffic as I did and had the warning “BLIS maintenance required” never before. Does another BLIS driver know something about this? I am therefore a bit on the foot of the war with BLIS – it is hardly to be used in daylight, because the LEDs are too dark and do not sit in the mirror, as for example with Mercedes, where you always look. In the city it generally brings very little (but is sometimes really helpful), but always I don’t want to turn it off – rarely there are moments where BLIS is helpful. However, I will never fix anything on the system, daf it’s just too expensive with too little use for me. But if there are software updates or little tricks, I’d love to hear them…