Hello everyone, I bought my old Rex Scooter 50 a new carburetor. The “original” was a Mikuni 12mm. Now a Dellorto replica 14mm. I was able to tune the carburetor quite well and once it is on it runs great. My problem: when he has stood up for a day, I have to start it for ever. It starts immediately, but also goes out immediately. Every time he tries to restart, he stays on for a few seconds until he stays on after a felt 100 kicks. I also turn it off for hours and it starts again immediately. My guess: it gets too fat mixture at the beginning and when ticking, the E-Choke needle continues to close until it closes and the scooter stays on. I don’t know if that’s right and what I can do about it? Put needle a little deeper? For a hot tip I would be very grateful.