Hello municipality With my R8 the dust protection mesh (cross-linker right) is capped, see attached picture! Is actually only “a small hole” in the cuff, where everything is dry, nothing leaks or is knocked out! Now I have inquired at Audi about the exchange of the cuff (though such a cuff can not cost the world) then the estimate: 4.701,83.- “Answer from Audi: here you get the estimate for the desired work. The reason for the installation is that the dust protection cuff is not available individually, so that the crossbar has to be replaced. However, this crossbar has been replaced from 2011 and has no M12 head anymore, but an M14, so that both the wheel bearing housings and the lower crossbars have to be replaced. In this case the front axle also has to be adjusted again” I thought only I am in the wrong movie… Unfortunately this is sad reality (see KVA) My question: only because of e in the “Cheap Cuff” immediately sums up the whole “front axle” to exchange, there is any cheaper solution than a repair of 4701,83.- ? Actually I could leave everything like this (as described nothing wasted or knocked out), but I have to go to the TÜV next month.If the one faults this cuff, this must be done! Does someone have an idea/solution that is cheaper (except I sell the whole box…)