Hello together, today again something from the category „do-it-yourself: The lighting in the frunk is well known to be expandable, so now there is a like I find optically very appealing solution to buy from Ali: https://de.aliexpress.com/item/1005004752904359.html Installation is very easy and goes plug&play by plug at the opening button, the light conductor itself is simply pushed under the seal and the set used by me fits both for vehicle e with 12V as well as 16V on-board system – can be converted/coded for this purpose by slider at the control unit (see annex, with me the setting for 12V to see, but also an instruction in English is included in the set) and for each year of construction suitable cables are included. In the Model 3 with „oldem–Frunk I had to cut off about 1cm of the light conductor (for this are marked on it), for other models or years of construction it probably fits without cutting. either easy to clamp in, the nicer solution is to fill out the cover a little bit, so that the cable can be laid without being clamped in. I chose the white version, but there are also other colors or a variable version with remote control for the frunk disc. If someone asks how long that lights up: After about 10 minutes the light goes out on its own, then you can either activate it again through the unlock button in the frunk or the frun k close and open again. In addition to the attractive look, the lighting of the frunk is also significantly improved. The last two pictures in the appendix show the result. __ The theme fits for 3 and Y equally, therefore the thread is mirrored in both subfora.