I have a question, and that is: My scooter didn’t jump, following it was removed from me by a buddy of the carburetors, where the water was seen in the carburetor. Unfortunately, the seal was not carefully removed from the float chamber, but pulled out. Then he cut off a piece of the seal, so it fit again and put it in. The scooter was then assembled, still did not jump on. In the carburetor water had been, how much I know unfortunately Icht. Then he screwed this airscrew half to the right, so that it gets fatter. Then he jumped on. What he now unfortunately has, at 30 he goes down briefly, but pulls immediately again. Unfortunately he now only drives 40 on the straight, 45 down the mountain. But one day BEFORE it was like that he drove 50 on straight and mountain down 55 around. It is a Kymco Super 8 2 timer built in 2017 740 kilometers on it. Then turned again at the airscrew to the left, then wur He pulls off well at the beginning, but at 20 it is already like walking away from the gas very briefly, minimally as if he lost power. Then he goes up to 35, after that it is again like walking away from the gas for a short time. That looks like he wanted, but he can’t open before the carburetor he drove great, 50 on the straight, 55 mountain down. The wheel turns only minimally when he runs, at the beginning he turns high until he just starts to jump on he does sup he. He also pulls well at the beginning. Do you know what that can be? Does he hang it together with this float chamber seal which was cut and re-installed? Am I desperate, since he drove still smoothly the day before ?? The seal was practically emptied from the float chamber from pulling and did not fit in any more, therefore he shortened it. I ordered a new seal.