Huhu I have now finally taken off the round turned heads with a slot screwdriver + hammer. Clean thing New screws + spring rings are already ready. Now I finally see my gas needle, which has a clip to adjust (4 steps). Currently the clip is on the 3 stage (see picture) My main nozzle set has also arrived, consisting of 80, 82, 84, 86 , 88, 90 (4mm Bring) My carburettor: https://www.ebay.de/…/182688643854?… Main nozzle 82 (4mm Bing) Side nozzle 33 A close-wide suction nozzle 28mm connection width air filter 38mm ZK greyish / white, so much too lean. Valve nozzles are re-set a few days ago ( 0.1 / 0.1 ) Which main nozzle should I start with? I fav. now the 84 and need another tip what do I do with the clip for the gas needle? So set higher equally fatter? Or just change the clip and leave the 82 HD in it? many thanks