Hi, I’m on the we unfortunately my woofer burned down. the components: AMP: DLS A6 monoblock, over 1000W.rms at 2 ohms, outstanding damping factor SUB: Hollywood Edge 1524 D4, 38cm Subwoofer 2×4 Ohm double swing coil AND: additional battery Stinger SPV35, disconnection relay and wiring 35mm2 box: about 90 liters (in a 1ser trunk!!) with self-made pre-calculated wooden port woofer has been recorded over 40 hours with 20 Hz and nem stroke from 5 to 20 mm free-hanging the lifetime was a week! settings at the amp were 2/3 load, separation at 75 Hz, the engine was running, amp wasn’t even warm at the housing, and time of the music about 30 seconds woofer has worked many times on the same day but never for long! after that the woofer fell out and squirted fiercely in front of him oh and he wasn’t clipping! how can I prevent such a thing?? I can’t touch the magnet and control the temperature! what should I do??