The transverse handlebar screw on the Audi A6 is so fixed that it has more than 200 newtonmeters of torque before it goes back again, can be rotated at a maximum of 90° and then starts to become crooked. Unfortunately, I already sunk the thread, and I don’t know which tool I should pull the screw out of the head now. With the Meiselhammer it doesn’t go any further because the angle is not right and also with a huge hammer with 2.5 joules impact force the screw no more millimeters go out t. Drilling doesn’t work either because no access fender blocks the angle. I know all the common methods like pulling out on the thread with the press-air hammer or any expressions, all this can’t be done, I need a tool to pull out