Hello everyone… I’m new here in the seat area of the forum, because it’s a second vehicle and I’m otherwise drifting around in the VW corner Have a question and hope someone can give me a helpful info…. I’ve been driving as a second car for a short time 6k2 as a cupra version with the 1.8t MKB: AQX (156ps) and 156 ps bj 2000 factory side. The following modifications were made to the car: k04 loaders, injection nozzles/air mass meters/gas pump/LK/N75 valve from the audio S3 (1.8t/224 ps), 3 inch stainless steel AGA, downpipe, 100 cells Rennkat, k&n Filter…. The car has now 211 ps, only a reasonable performance increase by chiptuning has not been made and should now follow, since many cars already in the standard condition without these whole hardware have to make changes to this performance… Now to my question: has possibly already done a similar conversion and can report from his experiences on how much ps/nm you can anticipate with these The vehicle now has 186,000 km down, a lot has been renewed and regular service with reasonable oil has been carried out, the engine is running perfectly and is already pressing tremendously … I thank you for your answers Downpipe,100 cell