Hello all cruiser users (and all those who want to be) I have not found a meaningful connection when activating the cruiser…(manual transmission!) If the cruiser function is active, then the cruiser is taken back by clutch / accelerator or brake. If I want to use it over + or – again, it can happen that the current value is not taken over and I have to press the + button several times. Just when driving slowly at 60 km/h others are already driving so close that they can clean my rear window (because I’m getting slower now if the cruiser does not regulate). Who can tell me how to keep the current speed safe. I have tried to press + for a while, but also did not bring the result. I don’t play around with the pedals either… I’m too stupid??? First a key click must be installed which says: exactly right pressed, bingo! The keys are usually also causing problems to change the speed. If it’s because the CAN bus is sometimes not registered because otherwise important or what’s going on?