Hello everyone, now for a few months also a 901 CC(MY1988), am so far very satisfied with it. So far I had the phenomenon from time to time that the reverse movement did not want to be put into place properly. With the advice of a forum member, in such cases before to turn into the first or third gear helped only conditionally. Sometimes I had to go into the idle, give a short gas, so that the gears changed and then This phenomenon occurred only about every 10th to 20th time at the parking, so far I accepted it as a small Macke. Now, however, in the last weeks I had three times the following event: During the ride suddenly the 5th gear did not insert itself correctly. If you push the shift stick from the 4th gear forward to the right, you automatically land far to the right, as if you wanted to insert the reverse gear. Besides that you can of course scare well behind a driving vehicle 😉 nothing actually happens. At the last time I found it by gently “stirring around” in the vicinity of the 5th gear. So it can still be inserted if you find the right position with the shift lever very carefully. But the “guide” to the right is then no longer available. The phenomenon then disappears again at the next turning off of the engine. Since the G If there are no other problems, I suspect the cause rather in the ignition lock area at the reverse lock. Does someone have experience and can say more about it? Thank you and many greetings, Nibohr