Dear Schraubergemeinde, I’m addressing you again with a question about my R60/5. I’ve done a great service at the beautiful 2-valve year 1972, a great service. Oil change (20W50) with filter, transmission, swing and end drive oil renewed, air filter tested and cleaned, valve play set. Everything works so far, the BMW drives well, the heads are perhaps a bit loud although I have set both outlet and inlet valve with 0.15mm. I know that A The problem now is that the oil control lamp only runs out from about 4000 revolutions. In idle mode it lights up very brightly and with increasing speed it gets darker until it goes out beyond the 4000 revolutions. I checked the oil level several times and installed an oil filter according to manufacturer specifications. I am now at the end with my Latin and hope to get some good information on how to disable this error. before the oil and filter change this error never occurred. Thanks in advance, Biker’s greeting Heinrich