Hello, I had a driving accident with subsequent fall on the right side. Luckily not much happened to me, the accident should not be possible here either. On the motorcycle the oil cooler was pressed in front, the pulpit was naturally broken in a place, the gear switch was broken and you could, because the disguise is not fully tilted anymore. I drove the machine still test-wise (of course before oil cooler, gear shift changed and the disguise sow It was all right. However, the panel at the bottom simply didn’t fit, so I changed the following: Fork completely fork bridge at the top and bottom Changed axle Changed mudguard at the front And as said oil cooler and gear shift. Unfortunately, the panel still doesn’t fit at the front, it comes to the front. The fixed point on the housing on the left(Kupp) It is strange that nothing was bent from the things I changed, i.e. fork, fork bridge, etc. Does everything look straight. Do I make a mistake of thinking? Or are the aluminum frames simply very soft, softer than the fork and the bridges? With a photo of the distance to the oil cooler. I would be pleased about a few opinions. PS: how expensive is it to change the frame? I am clear that there is nothing wrong with this. , actually I have to build the whole motorcycle from right to left. But I didn’t have to do such a big conversion yet. I’ve already changed wiring harness and how to work on it can be seen clearly more.